Search
Now showing items 1-10 of 13
Application of Model Order Reduction to Compressor Aeroelastic Models
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A model order reduction technique that yields low-order models of blade row unsteady aerodynamics is introduced. The technique is applied to linearized unsteady Euler CFD solutions in such a ...
Controls and Diagnostics Committee Best 1994 Paper Award: Modeling for Control of Rotating Stall in High-Speed Multistage Axial Compressors
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Using a two-dimensional compressible flow representation of axial compressor dynamics, a control-theoretic input–output model is derived, which is of general utility in rotating stall/surge active ...
Active Stabilization of Surge in an Axicentrifugal Turboshaft Engine
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Active stabilization of surge was implemented on an Allied Signal LTS-101 axicentrifugal gas producer, reducing the surging mass flow by 1 percent, for an operating range increase of 11 percent. ...
Active Stabilization of Axial Compressors With Circumferential Inlet Distortion
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper describes the first experimental validation of transfer function modeling and active stabilization for axial compressors with circumferential inlet distortion. The inlet distortion ...
Prestall Behavior of Several High-Speed Compressors
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: High-speed compressor data immediately prior to rotating stall inception are analyzed and compared to stability theory. New techniques for the detection of small-amplitude rotating waves in the ...
Stall Precursor Identification in High-Speed Compressor Stages Using Chaotic Time Series Analysis Methods
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents a new technique for precursor identification in high-speed compressors. The technique is a pseudo-correlation integral method referred to as the correlation method. To provide ...
Closure to “Discussion of ‘Stall Precursor Identification in High-Speed Compressor Stages Using Chaotic Time Series Analysis Methods’” (1997, ASME J. Turbomach., 119, p. 499)
Publisher: The American Society of Mechanical Engineers (ASME)
Tip Clearance Actuation With Magnetic Bearings for High-Speed Compressor Stall Control
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Magnetic bearings are widely used as active suspension devices in rotating machinery, mainly for active vibration control purposes. The concept of active tip-clearance control suggests a new ...
Active Control of Rotating Stall in a Low-Speed Axial Compressor
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The onset of rotating stall has been delayed in a low-speed, single-stage, axial research compressor using active feedback control. Control was implemented using a circumferential array of hot ...
Rotating Stall Control in a High-Speed Stage With Inlet Distortion: Part II—Circumferential Distortion
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents the first attempt to stabilize rotating stall in a single-stage transonic axial flow compressor with inlet distortion using active feedback control. The experiments were ...